With Windows, it is reported that all FJ scanners have a problem when operating. The most popular USB interface is called Version1. Use the following procedure to make the scanner select one of the four product IDs: Sensor location MGX Figure 2. When the scanner enters ID change mode, the lamps are turned on or off as shown in Table 1 for the product ID change mode. The transition status is recognized by the LEDs.
|Date Added:||13 August 2008|
|File Size:||12.47 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Is the scanner supported by the driver connected? The transition status fujtisu recognized by the LEDs. Fujitsu fi Series Image Scanner Product. Is the power cable of the scanner connected correctly and the scanner power turned on? With Windows, it is reported that all FJ scanners have a problem when operating.
Probable trouble at scanner connection.
Software Downloads: MGX / MDG / MGX / MDC / MDC – Fujitsu Global
However, the effective speed of this interface is 1MBPS. Please check the followings.
Is the terminator set properly? When using MD under Windowsa problem is reported that the endorser imprinter can not print correctly. This message appears when the driver can not receive answers from the scanner. Is the power of the scanner turned on before turning on the power of PC? We are confirming a detailed cause. Sensor location MGX Figure 2. Please check the following items first. Use the following procedure to make the scanner select one of the four product IDs: If the lamps are not turned on or off as shown in Table 1, repeat this step.
We have no plan to support this problem, please use another board. The file has not been installed or have deleted.
The most popular USB interface is called Version1. Contacts Related links Sitemap. Is your diver of SCSI board installed correctly? Open the ADF cover all the way. Are the terminators of all devices set correctly?
Turn the power on while pressing the OMR sensor. After confirming the lamps in step 2press the B5-size sensor again. Some causes are probable regarding this error message. Is the option board of the m303dg installed correctly?
Introduction of End of Life product “M3093DE/DG”.
Changing product identification 4. This information is released as of December Is the power of the scanner turned on? DILL using 16 bit version are not found.
There is not any problem with WindowsNT 4. Is the scanner in the state of “Ready to operate”? Does your driver support your operating system? When you stop pressing the OMR sensor, the lamps are turned on or off as shown in Table 1 according to the current ID.